A bench for the ‘new’ lathe

After cleaning up the lathe and removing some surface rust, it was time to make a bench. Having a good selection of used heating pipes in various diameters up to 4” provided lots of options. A gifted Mig welder topped off the setup.

Pipes and 1 1/2×1 1/2 angle iron were cut to length and welded up into 3 leg assemblies. 2 layers of wood bonded together form the top. The 2 main areas are further strengthen with 2×4’s on edge, glued and screwed to the bottom of the top.

20161010_14485920161010_151232

The end result is a very sturdy arrangement for the lathe and milling machine.

20161015_154524

Comments are closed.